Easy Calibration for Boom Sprayers
Introduction
Calibrating spray equipment is an important first step when applying pesticides, fertilizers, and other chemicals. If nozzles are not properly calibrated, it can result in over or under application of chemicals, causing crop damage, reduced pest control, and potential safety concerns. Making the effort to properly mix chemicals and calibrate sprayers can save money and headaches in the long run. This fact sheet provides simple guidelines for calibrating boom sprayers.
Sprayer Calibration Benefits
- Apply chemical uniformly and in accordance with label-recommended application rates.
- Maximize the efficacy and reduce variation of the chemical applications, resulting in better crop performance, yield, and profit.
- Avoid inaccurate and non-uniform applications, which can violate label restrictions, waste resources (time, fuel, chemical), and cause environmental harm.
Getting Started
Calibration is measuring how many gallons the sprayer applies per acre. Because there are 128 ounces (oz) in 1 gallon (gal), it is possible to calculate the gallons sprayed per acre by measuring the number of ounces applied to 340.3 ft2 (1/128 acre) (Ferrell, 1998; Figure 1). This method requires little math.
Equipment Inspection
- Clean, and inspect the equipment to ensure that it is free of pesticide residue and in working order.
- Check nozzles for functionality and uniform spray pattern.
- Measure the amount of water sprayed by each nozzle for 30 seconds using a catch cup or graduated measuring container. All nozzles should emit within 10% of the average of all the nozzles. If not, the nozzle may need to be cleaned or replaced. Note: Do not clean nozzles with your bare hands or mouth. Use appropriate tools or compressed air.
- Does the spray pattern appear even or as advertised by the manufacturer? If not, clean or replace the nozzle.
- Do any nozzles leak after the sprayer is turned off? If so, the manifold check valve may need to be replaced.
- Once equipment passes inspection, proceed to calibration.
Calibration Steps
Step 1
Count the number of nozzles on your boom sprayer and measure the distance between them (Figure 2a).
Number of nozzles: _________ Distance (in.): _________
Step 2
Use Table 1 to calculate the driving distance that equals 1/128 acre.
Table 1.
Calibration Distance for Each Nozzle to Spray 1/128 Acre*
| Nozzle/row spacing (in.) | Travel distance (ft) |
|---|---|
| 18 | 227 |
| 20 | 504 |
| 22 | 185 |
| 24 | 170 |
| 26 | 157 |
| 28 | 146 |
| 30 | 136 |
| 32 | 127 |
| 34 | 120 |
| 36 | 113 |
| 38 | 107 |
| 40 | 102 |
* Table modified from Ozkan, 2016.
Step 3
Time yourself driving the distance indicated in Table 1. It is important to be as consistent as possible with the speed of the vehicle (gear, range, RPMs). You can repeat this step and average your driving time to increase your accuracy. An example is included in Figure 2b. Write down the average driving time in seconds.
Average driving time (seconds): _________
Step 4
Fill your sprayer with water (pesticide residue should have been removed beforehand) and use a fluid ounce measuring container to catch water from each nozzle for the time you wrote down in step 3. Write down the number of ounces collected for each nozzle and then calculate the average (add the ounces for each nozzle and divide the answer by the number of nozzles).
Average oz/nozzle: _________
Congratulations! The average ounces per nozzle equals the number of gallons per acre. For example, 15 oz per nozzle = 15 gal gallons per acre.
Write down your gal per acre here: _________
Date: _________
Photo Credit
Authors provided all photos.
References
- Ferrell, M. A. (1998). 1/128 method of calibration: Calibrating hand sprayers and high pressure hand guns [Fact sheet MP-93.3]. University of Wyoming Extension. https://uwyoextension.org
- Ozkan, H. E. (2016, April 4). Boom sprayer calibration [Fact sheet FABE-520]. Ohioline, Ohio State University Extension. Retrieved November 12, 2019, from https://ohioline.osu.edu/factsheet/fabe-520.
Published November 2022
Utah State University Extension
Peer-reviewed fact sheet
Authors
Cody Zesiger, Kalen Taylor, Corey Ransom, Earl Creech, and Matt Yost
Kalen Taylor
Extension Assistant Professor | Agriculture | Millard County
Agriculture and Natural Resources
Cody Zesiger
Extension Assistant Professor | Agriculture & Natural Resources | Weber, Morgan and Davis Counties
Agriculture and Natural Resources
Related Research
4R’s of Irrigation Management
The research community and fertilizer industry have developed and utilized a framework termed “4R nutrient management” to help improve fertilizer stewardship. For decades, national and international organizations and institutes such as The Fertilizer Inst
Accurate Irrigation Water Flow Measurement in Pipes
Accurate flow measurement is important to irrigation water management and water rights accounting and protection. Accurate flow measurement is essential in ensuring equitable water distribution to water rights holders and shareholders within irrigation co
County-Level View of Irrigation Trends in Utah and the West
As water demand and scarcity increase simultaneously over the coming decades, water managers and growers will need to optimize water use on their irrigated lands. These challenges have been especially noticeable as the Western U.S.faces a prolonged “megad
Defense Against Drought
Utah’s climate can often be harsh and unpredictable. As the nation’s second driest state, Utah is commonly subject to droughts. Extensive statewide droughts have often lasted 5 to 6 years. It is imperative that farmers are well prepared to defend against
Deficit Irrigation of Pastures
Deficit irrigation is any irrigation level that does not meet the crop’s full evapotranspiration (ET) demand, meaning evaporation from plant and soil surface and transpiration through plant growth.
Drought Tolerance Guide for Alfalfa in Utah
Crop variety selection is one of the most important choices on the farm. Crop genetics determine a significant portion of the yield potential and resource use efficiency. Crop types and genetics that use water more efficiently will become increasingly imp
Economic Feasibility of Solar Photovoltaic Irrigation Systems
The Great Basin is primarily located in Nevada, western Utah, and small sections of southern Oregon and Idaho. The Great Basin is noted for its arid conditions and high percentage of publically owned land. The potential for solar energy generation in the
Energy Conservation with Irrigation Water Management
Irrigators in Utah experienced rapidly increasing energy costs from the mid 1970s to the late 1980s. These costs remain relatively high. Those who are pumping from deep wells are particularly interested in ways to cut back on energy use without doing away
Guide to Irrigation Sprinkler Packages for Pivots and Laterals
Guide to Irrigation Sprinkler Packages for Pivots and Laterals
How Good is Your Water Measurement?
Accurate water measurement is essential to maintaining equity of water delivery within an irrigation company or water districts. Good management of our scarce water resource is dependent upon quantifying supplies and uses with accurate measurement techniq
Irrigation Canal Lining?
Irrigation canals placed in native soil or lined with earth can have seepage water losses varying from 20 percent to more than 50 percent. Well designed, new compacted earth lined canals can have reduced seepage losses similar to concrete lined channels.
Irrigation Water Loss and Recovery in Utah
When deciding which irrigation systems to adopt, permit, or promote, it is important to consider how their efficiency and losses affect the water balance of Utah’s watersheds and drainage basins. Irrigators have no control over precipitation and only limi
Irrigation Water Quality Sampling Guide
The suitability of a water source for irrigation depends on the water quality, and some sources may be altogether unsuitable for practical use.
Managing Saline and Sodic Soils and Irrigation Water
Salt is important in plant and soil management. Excessive salt concentrations in soil can cause water to be less available to plants because of the osmotic forces of salt in the soil water. Excessive concentrations of some salt ions can also be toxic to p
Managing Soil pH for Crop Production in Calcareous-Alkaline Soil
In semiarid soils of the Western U.S., altering soil pH is not easily accomplished nor straightforward. Recall that pH is a measure of the acidity or alkalinity of a substance. More specifically, Utah’s soil pH range can be 1,000 times more acidic or alka
Mobile Drip Irrigation for Pivots and Laterals
New technologies like MDI have the potential to improve irrigation efficiency thereby increasing water available to the crop and conserving water by reducing loss. If you are considering MDI on your farm, it will be important to carefully review its poten
Precision Irrigation Guide for Center Pivots
Precision irrigation is a process involving technology and specialized equipment to improve the efficiency and effectiveness of agriculture irrigation management. This management process is beneficial in allocating water based on spatial variability throu
Soil Sampling Guide for Crops
Why conduct soil sampling for crops? The answer is simple and intuitive for most involved in agriculture. Regular soil sampling, testing, and associated guidance on fertilization and soil amendments help develop and maintain more productive and healthy
Strategies for Deficit Irrigation of Forage Crops
Deficit irrigation strategies with varying effectiveness can be employed in many cases to maximize production and profit. These strategies can include modifying irrigation schedules, concentrating irrigation to critical crop growth stages, reducing rates,
Ten Considerations for Solar-Powered Irrigation in Utah
Generating power from solar energy used to be one of the most expensive options in Utah. This scenario is changing. According to the American Council on Renewable Energy (ACORE, 2021), the cost of solar power production went down by 90% between 2009 and 2
Understanding Irrigation Water Optimization
It is important to consider the possible hydrologic impacts of irrigation optimization efforts to avoid implementing practices that have little appreciable effect relative to the desired outcome. Examples of desired outcomes include increasing supply reli
Variable Frequency Drives for Irrigation Pumps
A VFD can make sense in a variety of irrigation applications. Here are 6 of the major applications where one might consider a VFD (also see Henry and Stringham, 2013 and USDA-NRCS, 2010):
Water Rights in Utah
If you are connected to a municipal system, your water is probably categorized as “culinary or municipal water” and is used for everything from drinking and bathing to washing the car to watering tomatoes. However the Utah Division of Water Rights takes a
25 Rules of Thumb for Field Crops
University Extension services are widely known for scientific information on best practices for field crop production. Many Extension experts commonly offer the same tips or "rules of thumb" to growers. This article is certainly not a comprehensive list o
Irrigation Advance Sensors Are Having Large Impacts in Surface Irrigation
There are many good things about surface irrigation, but the labor requirements and large water withdrawals can diminish its feasibility in situations with limited access to labor or water. In this fact sheet, we will describe two of these systems current